In winter, low temperatures, have warm up each petal building a hairdryer to bitumen softening and bonding was strong. In hot weather the same tiles should be kept in the shadows, to ensure easy installation and easy removal of plastic film. There is one very important obstacle to laying tile – rain. You need to wait when the roof is completely dries out. Most easily fit the tiles with self-adhesive layer and protective film. In this case: the film is removed prior to installation, and each tile is attached to the base with nails or without them (for some types of tiles). After that, under the influence of solar heat, is sticking lower surface tile to the base and the neighboring tiles.

Resulting in a tight roof covering. Since the tile is laid overlapped, the reliability of each still attached to the previous four special nails (Galvanized roofing size 30h10h3 mm). Upon completion of installation of the roof resembles a puff pie. Soft roof can be used and if the angle of roof pitch is less than 15?, However, require additional waterproofing layer. But for roofs with slopes greater than 60? (This is a threat to slate or metal profiled sheet for loosening screws), shingles is almost the only acceptable material. Underlayment waterproofing is needed in the valley, in the eaves, in the closures. Some manufacturers are advised to also purchase a roll of special 'ridge' tile.

As for accessories. For good homes need appropriate water drainage system. Coming from a cottage in the rapture, we do not think, than the integrity of the composition due to the building.